Cisco ASA 5505 Series Network Firewall ASA5505-SEC-BUN-K9 With SW,
UL Users
Description:ASA 5505 Sec Plus Appliance with SW, UL Users, HA,
3DES/AES.
The Cisco ASA 5500 Series brings a new level of integrated security
performance to networks with its highly effective IPS services and
multiprocessor hardware architecture.
This architecture allows businesses to adapt and extend the
high-performance security services profile of the Cisco ASA 5500
Series. Customers can add additional high-performance services
using security services modules with dedicated security
co-processors, and can custom-tailor flow-specific policies using a
highly flexible policy framework.
This adaptable architecture enables businesses to deploy new
security services when and where they are needed, such as adding
the broad range of intrusion prevention and advanced anti-worm
services delivered by the IPS modules via IPS SSP, AIP SSM and AIP
SSC, or the comprehensive malware protection and content security
services enabled by the CSC SSM. Further, the architecture allows
Cisco to introduce new services to address new threats, giving
businesses outstanding investment protection for the Cisco ASA 5500
Series.
Quick Specs
Table 1 shows the Quick Specs.
Firewall ASA5505-SEC-BUN-K9 |
Firewall Users | Unlimited |
Maximum firewall throughput (Mbps) | 150 |
Maximum connections | 25,000 |
Maximum connections/second | 3,000 |
Packets per second (64 byte) | 85,000 |
Application-layer security | Yes |
Layer 2 transparent firewalling | Yes |
Security contexts (included/maximum)3 | 0/0 |
GTP/GPRS inspection3 | Not available |
VPN |
Maximum 3DES/AES VPN throughput (Mbps) | 100 |
Maximum site-to-site and remote access
IPsec VPN user sessions | 25 |
SSL user session license included | 2 |
Maximum SSL VPN user sessions1 | 25 |
VPN clustering and load balancing | Not available |
UTM Features Included |
Intrusion Prevention Included (Performance) | No |
Content Security [anti-virus, anti-spyware,
file blocking, anti-spam, anti-phishing,
and URL filtering] (Max users) | No |
Other Features |
Integrated ports2 | 8 port 10/100 switch with 2 Power over Ethernet ports |
Maximum virtual interfaces (VLANs) | 20 (trunking enabled) |
High availability support4 | Stateless A/S |
Connecting the Interface Cables
This section describes how to connect the cables to the Ethernet
and Console ports.
Warning Only trained and qualified personnel should install, replace, or
service this equipment. Statement 49
Caution Read the safety warnings in the Regulatory Compliance and Safety
Information for the Cisco ASA 5505 Adaptive Security Appliance and
follow proper safety procedures when performing these steps.
To connect cables to the ports perform the following steps:
Step 1 Place the chassis on a flat, stable surface.
Step 2 Before connecting a computer or terminal to the ports, check
to determine the baud rate of the serial port. The baud rate must
match the default baud rate (9600 baud) of the Console port of the
adaptive security appliance. Set up the terminal as follows: 9600
baud (default), 8 data bits, no parity, 1 stop bits, and Flow
Control (FC) = Hardware
.
Step 3 Connect the cables to the ports.
a. Ethernet ports
Step 1 Connect Port 0, the outside Ethernet port, to the public
network, that is, the Internet:
Note By default, switch port 0/0 is the outside port. If needed you can
change the inside and outside ports assignments later.
Step 2 Connect your network devices with an Ethernet cable to one
of the inside ports (numbered 1 through 7).
If you are connecting any PoE devices, connect them to one of the
switch ports that support PoE (ports numbered 6 and 7).
Step 3 Check the LINK LED to verify that the network devices have
basic connectivity to the Cisco ASA 5505 on one of the inside ports
(numbered 0 through 7). When connectivity is established, the LINK
LED on the front panel of the Cisco ASA 5505 lights up solid green.
Figure 2 Connecting Cables to Network Interfaces
① | RJ-45 Ethernet ports | ② | RJ-45 connector |
Step 4 Connect the power cord to the adaptive security appliance
and plug the other end to the power source. For information on
powering on the chassis, see the “Powering on the Cisco ASA 5505”
section
Our Advantage
1. Extensive Real Inventory
2. Save up 50%-99% off the Global Price list
3. Flexible payment shipment
4. Unparalleled Experience Service
Shipping:
1. Fast: in 2-3 days upon receipt of payment.
2. Safe: original package with protection foam in case of equipment
broken in transportation.
3. Economic: Low cost express fee via DHL, Fedex, TNT,EMS,Postal etc.
4. Flexible: We also ship to your Assigned Forwarder or Pickup by
your forwarder.
